Ntp 128-2: I-010G-Q And I-010G-S Indoor Ont Connections (Back View) - Alcatel-Lucent 7302 Information Manual

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

Figure NTP 128-2: I-010G-Q and I-010G-S indoor ONT connections (back view)

Replace the old ONT with a new unit.

Connect the Ethernet cable to the RJ-45 port (DLP 101).

If required, have approved service personnel who are trained to work with optic

fiber clean the fiber optic connection. See DLP

fiber optic handling, inspection, and cleaning.

Connect the fiber optic cable to the SC/APC connector on the ONT (DLP 133).

Connect the power cable with an AC/DC adapter to the ONT unit power connector;

as shown in Figure

If used, configure the SLID (DLP 129).

Verify the ONT LEDs and voltage status (DLP 127).

Activate and test the services (DLP 128).

If necessary, reset the ONT (DLP 126).

STOP. This procedure is complete.

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

3FE 55873 AAAA TCZZA

ONT Product Information Guide

NTP 128 — Replace an I-010G-Q or I-010G-S indoor ONT

Danger — Fiber optic cables transmit invisible laser light. To avoid eye

damage or blindness, never look directly into fibers, connectors, or

Warning — Be careful to maintain a bend radius of no less than 1.18

inches (3.0 cm) when connecting the fiber optic cable. A bend radius in

the cable that is too small can damage the optic fiber.

Note — A new SLID or the old SLID may be used with the replacement

ONT. If a new SLID is used, the new SLID must also be programmed at

the P-OLT using TL1 or a network manager. If the old SLID is used, no

changes need to be made at the P-OLT; see the Operations and

Maintenance documentation for the I-010G-Q or I-010G-S for more

for more information about

November 2013