Environmental Standard Compliance; Electrical Safety Guidelines; Power Supplies; Cabling - Alcatel-Lucent 7302 Information Manual

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

ETSI ONT safety guidelines

Environmental standard compliance

The ONT equipment complies with the EN 300 019 European environmental

Laser product standard compliance

The ONT equipment complies with EN 60825-1 and IEC 60825-2 for laser products.

The ONT equipment complies with the requirements of ITU Recommendation K.21

for resistibility of telecommunication equipment installed in customer premises to

over voltage and overcurrents.

Acoustic noise emission standard compliance

The ONT equipment complies with EN 300 753 acoustic noise emission limit and

test methods.

This section provides the electrical safety guidelines for the ONT equipment.

The use of any non-Alcatel-Lucent approved power supplies or power adaptors is not

supported or endorsed by Alcatel-Lucent. Such use will void any warranty or support

contract with Alcatel-Lucent. Such use greatly increases the danger of damage to

equipment or property.

The following are the guidelines regarding cables used for the ONT equipment:

All cables must be approved by the relevant national electrical code.

The cables for outdoor installation of ONTs must be suitable for outdoor use.

POTS wiring run outside the subscriber premises must comply with the

requirements of local electrical codes. In some markets, the maximum allowed

length of the outside run is 140 feet (43 m). If the outside run is longer, NEC

requires primary protection at both the exit and entry points for the wire.

November 2013

The ONTs comply with the U.S. National Electrical Code.

However, local electrical authorities have jurisdiction when there are

differences between the local and U.S. standards.

The ONTs comply with BS EN 61140.

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

3FE 55873 AAAA TCZZA

ONT Product Information Guide