Resistibility Requirements Compliance - Alcatel-Lucent 7302 Information Manual

Figure 2 Sample laser product label showing CDRH 21 CFR compliance
No User Serviceable Parts Inside. Refer All Servicing To Qualified Personnel.
4P92
I.T.E
Complies with 21 CFR 1040.10 and
1040.11 except for deviations pursuant to
Laser Notice No. 50, dated June 24, 2007.

Resistibility requirements compliance

The ONT equipment complies with the requirements of ITU Recommendation K.21
for resistibility of telecommunication equipment installed in customer premises to
overvoltage and overcurrents.
Laser safety guidelines
Only qualified service personnel who are extremely familiar with laser radiation
hazards should install or remove the fiber optic cables and units in this system.
Observe the following warnings when you perform installation, operations, and
maintenance tasks on the ONT equipment.
Observe the following danger for a laser hazard. Eyes can be damaged when they are
exposed to a laser beam. Take necessary precautions before you plug in the optical
modules.
Per CDRH 21 CFR 10.40.10 (h) (1) (iv) distributors of Class 1 laser products, such
as ALU ONTs shall leave the following Laser Safety cautions with the end user.
a) "Class 1 Laser Product"
b) "Caution – Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure."
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
12VDC 2.5A
2301 Sugar Bush Rd.
Raleigh, NC 27612
Danger —
There may be invisible laser radiation at the fiber optic
cable when the cable is removed from the connector. Avoid direct
exposure to beam.
Danger —
Possibility of equipment damage. Risk of eye damage by
laser radiation.
ANSI ONT safety guidelines
FiOS Enabled
To Order FiOS: 888 GET-FiOS
or visit Verizon.com
For Service: 888 553-1555
November 2013
22813
xxvii