Figure 2-5 Sfu Cabling With And Without Moca - Alcatel-Lucent 7330 Product Information Manual

SFU customer premise
PC
IP
video
PC
CAT
IP video
TV
UPS
New cabling
Switching existing services from a service provider can be a challenge. For example,
an existing copper network interface device may be many feet away from the ONT,
while the coaxial splitter may be at the opposite end of the premises. In this case,
some of the options are:
•
Install the ONT on top of the existing network interface device and use the ONT
as the new network interface device.
•
Run copper and coaxial jumpers from the ONT to the network interface device
and the RF splitter.
New housing and MDU developments provide an opportunity to optimize the wiring
design to support the offered services. The options include:
•
specifying a central wiring and cabling closet or box
•
installing the ONT indoors and running fiber directly to the ONT from the outside
2.6 Planning maintenance
This section provides information about planning ONT maintenance.
Monitoring
The system provides maintenance tools. The 5520 AMS can be used to monitor
alarms and performance. In addition, TL1 and CLI commands can be used at the craft
terminal at the OLT or the ONT/MDU (if supported) to perform monitoring tasks.
Monitoring alarms and performance provide some troubleshooting, but do not
provide the granularity needed for fault isolation.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
2 — Part numbers, ordering, and deployment configuration overview

Figure 2-5 SFU cabling with and without MoCA

TV
CAT
Coax
ONT
CAT
Coax
DC power
Edition 01 ONT Product Information Guide
SFU customer premise w/MOCA
PC
PC
CAT
MOCA
TV
March 2011
TV
CAT
MOCA
MOCA
DC power
UPS
ONT
19441
2-21