Environmental Standard Compliance; Laser Product Standard Compliance - Alcatel-Lucent 7330 Product Information Manual

ETSI ONT safety guidelines

Environmental standard compliance

The ONT equipment complies with the EN 300 019 European environmental
standards.

Laser product standard compliance

The ONT equipment complies with EN 60825-1 and IEC 60825-2 for laser products.
Resistibility requirements compliance
The ONT equipment complies with the requirements of ITU Recommendation K.21
for resistibility of telecommunication equipment installed in customer premises to
over voltage and overcurrents.
Acoustic noise emission standard compliance
The ONT equipment complies with EN 300 753 acoustic noise emission limit and
test methods.
Electrical safety guidelines
This section provides the electrical safety guidelines for the ONT equipment.
Power supplies
The use of any non-Alcatel-Lucent approved power supplies or power adaptors is not
supported or endorsed by Alcatel-Lucent. Such use will void any warranty or support
contract with Alcatel-Lucent. Such use greatly increases the danger of damage to
equipment or property.
Cabling
The following are the guidelines regarding cables used for the ONT equipment:
•
All cables must be approved by the relevant national electrical code.
•
The cables for outdoor installation of ONTs must be suitable for outdoor use.
•
POTS wiring run outside the subscriber premises must comply with the
requirements of local electrical codes. In some markets, the maximum allowed
length of the outside run is 140 feet (43 m). If the outside run is longer, NEC
requires primary protection at both the exit and entry points for the wire.
xii
Note 1 —
The ONTs comply with the U.S. National Electrical Code.
However, local electrical authorities have jurisdiction when there are
differences between the local and U.S. standards.
Note 2 —
The ONTs comply with BS EN 61140.
March 2011
ONT Product Information Guide Edition 01
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA