Table of Contents
Advertisement
700 mm
Adhesive Tape
Adhesive Tape
Protective Cover
20.
REMOVE FRONT PILLAR GARNISH LH
HINT:
Use the same procedures described for the RH side.
21.
REMOVE RH VISOR ASSY
(a)
Remove the 2 screws and visor.
22.
REMOVE LH VISOR ASSY
(a)
Remove the 2 screws and visor.
Claw
Claw
Claw
Claw
AVENSIS REPAIR MANUAL (RM1018E)
EXTERIOR/INTERIOR TRIM
–
(b)
Pull the garnish upward and remove from the instrument
panel.
(c)
w/ Curtain shield airbag:
120 mm
Protect the curtain shield airbag LH.
(1)
NOTICE:
Cover the curtain shield airbag with the protection cover as
soon as the front pillar garnish is removed.
B65292
23.
REMOVE MAP LAMP ASSY
(a)
Using a screwdriver, disengage the 6 claws and remove
the lens cover.
HINT:
Tape the screwdriver tip before use.
(b)
Remove the 2 screws.
(c)
Using a moulding remover, disengage the claws.
(d)
Disconnect the map lamp switch connector and sliding
roof switch connector, and remove the map lamp.
A79919
24.
REMOVE ROOM LAMP ASSY NO.2
(a)
Using a moulding remover, disengage the 8 claws and re-
move the lens cover.
HINT:
Tape the screwdriver tip before use.
(b)
Using a moulding remover, disengage the claws.
(c)
Disconnect the map lamp switch connector and remove
the map lamp.
B66541
http://vnx.su
ROOF HEADLINING ASSY (SEDAN MODELS)
Thoroughly cover the airbag with cloth or nylon of
700 mm (27.56 in.) x 120 mm (4.72 in.) and fix the
ends of the cover with adhesive tape as shown in
the illustration.
76–39
Advertisement
Table of Contents
