Table of Contents
Advertisement
HINT:
Tape the screwdriver tip before use.
8.
REMOVE REAR BUMPER RETAINER UPPER RH
HINT:
Use the same procedures described for the LH side.
9.
REMOVE REAR BUMPER SIDE MOULDING LH
(a)
Using a screwdriver, disengage the 10 claws and remove the moulding.
HINT:
Tape the screwdriver tip before use.
10.
REMOVE REAR BUMPER SIDE MOULDING RH
HINT:
Use the same procedures described for the LH side.
11.
INSTALL REAR BUMPER REINFORCEMENT NO.1
(a)
Install the reinforcement with the 8 bolts.
Torque: 11.5 N m (115 kgf cm, 16 ft lbf)
AVENSIS REPAIR MANUAL (RM1018E)
EXTERIOR/INTERIOR TRIM
–
12.
INSTALL REAR BUMPER COVER
(a)
Install the bumper cover with the 4 nuts, 2 screws and 3
clips.
Torque: 5.5 N m (55 kgf cm, 49 in. lbf) for screw
B67427
http://vnx.su
REAR BUMPER (SEDAN/LIFTBACK)
76–7
Advertisement
Table of Contents
