Table of Contents
Advertisement
Troubleshooting
3. If the wireless bridge cannot be configured using Telnet, a
web browser, or SNMP software:
•
•
•
•
4. If all other recovery measures fail, and the wireless bridge is
still not functioning properly, take any of these steps:
•
•
5. If you forgot or lost the password:
•
A-2
Be sure to have configured the wireless bridge with a valid
IP address, subnet mask and default gateway.
Check that you have a valid network connection to the
wireless bridge and that the Ethernet port or the wireless
interface has not been disabled.
If you are connecting to the wireless bridge through the
wired Ethernet interface, check the network cabling
between the management station and the wireless bridge.
If you cannot connect using Telnet, you may have
exceeded the maximum number of concurrent Telnet
sessions permitted (i.e, four sessions). Try connecting
again at a later time.
Reset the wireless bridge's hardware using the CLI, web
interface, or through a power reset.
Reset the wireless bridge to its default configuration.
Contact Technical Support.
Advertisement
Table of Contents
