Wireless Interface Commands - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Example
AP#show interface ethernet
Ethernet Interface Information
========================================
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Admin status
Operational status
========================================
AP#

Wireless Interface Commands

The commands described in this section configure connection
parameters for the wireless interface.
Command
interface wireless Enters wireless interface
description
ssid
closed system
speed
channel
turbo
beacon-interval
Wireless Interface Commands
: 192.168.2.2
: 255.255.255.0
: 192.168.1.253
: 192.168.1.55
: 10.1.0.55
: Up
: Up
Function
configuration mode
Adds a description to the wireless
interface
Configures the service set identifier
Prohibits access to clients without a
pre-configured SSID
Configures the maximum data rate
for transmitting unicast packets on
the wireless interface
Configures the radio channel
Configures the 802.11a radio to use a
faster proprietary modulation mode
Configures the rate at which beacon
signals are transmitted from the
wireless bridge
Mode Page
GC 7-99
IC-W 7-99
IC-W 7-104
IC-W 7-101
IC-W 7-101
IC-W 7-102
IC-W 7-103
IC-W 7-104
7-97