Table of Contents
Advertisement
Connect Cables to the Unit
1. Attach the Ethernet cable to the Ethernet port on the wireless
bridge.
Note: The Ethernet cable included with the package is 30 m (100 ft)
long. To wire a longer cable (maximum 100 m, 325 ft), use the
connector pinout information in Appendix B.
2. For extra protection against rain or moisture, apply
weatherproofing tape (not included) around the Ethernet
connector.
3. Be sure to ground the unit with an appropriate grounding wire
(not included) by attaching it to the grounding screw on the
unit.
Caution: Be sure that grounding is available and that it meets local and
Connect the Power Injector
To connect the wireless bridge to a power source:
Caution: Do not install the power injector outdoors. The unit is for
national electrical codes. For additional lightning protection,
use lightning rods, lightning arrestors, or surge suppressors.
Ethernet Cable
indoor installation only.
Connect Cables to the Unit
Ground Wire
4-7
Advertisement
Table of Contents
