SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 141

stop sending the SSID in beacon messages. Select a radio
channel or set selection to Auto using the channel command. Set
any other parameters as required. To view the current 802.11g
radio settings, use the show interface wireless g command.
AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
AP(if-wireless g)#description RD-AP#3
AP(if-wireless g)#ssid r&d
AP(if-wireless g)#channel auto
AP(if-wireless a)#closed-system
AP(if-wireless a)#transmit-power full
AP(if-wireless g)#speed 6
AP(if-wireless g)#max-association 32
AP(if-wireless g)#beacon-interval 150
AP(if-wireless g)#dtim-period 5
AP(if-wireless g)#fragmentation-length 512
AP(if-wireless g)#rts-threshold 256
AP(if-wireless g)#exit
AP#show interface wireless g
Wireless Interface Information
===========================================================
----------------Identification-----------------------------
Description
Bridge/AP
Service Type
SSID
Channel
Status
----------------802.11 Parameters--------------------------
Transmit Power
Max Station Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
DTIM Interval
Maximum Association
----------------Security-----------------------------------
Closed System
Multicast cipher
Unicast cipher
WPA clients
WPA Key Mgmt Mode
WPA PSK Key Type
Encryption
Default Transmit Key
Static Keys :
Key 1: EMPTY
Authentication Type
===========================================================
AP#
: Enterprise 802.11g Wireless Outdoor
: Access Point
: r&d
: 11 (AUTO)
: Enable
: FULL (14 dBm)
: 6Mbps
: 512 bytes
: 256 bytes
: 150 TUs
: 5 beacons
: 64 stations
: DISABLED
: WEP
: TKIP
: SUPPORTED
: DYNAMIC
: HEX
: DISABLED
: 1
Key 2: EMPTY Key 3: EMPTY
: OPEN
Radio Interface
7-120
Key 4: EMPTY
7-99
7-99
7-100
7-102
7-101
7-107
7-101
7-108
7-104
7-104
7-105
7-106
6-65