Table of Contents
Advertisement
Initial Configuration
The wireless bridge offers a variety of management options,
including a web-based interface, a command line interface (CLI),
or using SNMP management software.
Most initial configuration steps can be made through the web
browser interface using the Setup Wizard (page 5-4). However,
for units that do not have a preset country code, you must first set
the country code using the CLI.
Note: Units sold in some countries are not configured with a specific
country code. You must use the CLI to set the country code and
enable wireless operation (page 5-2).
The wireless bridge requests an IP address via DHCP by default.
If no response is received from a DHCP server, then the wireless
bridge uses the default address 192.168.2.2. If this address is not
compatible with your network, you can first perform initial
configuration using a PC that has IP settings compatible with this
subnet (for example, 192.168.2.3) and connecting it directly to the
wireless bridge. When the basic configuration is completed, you
can set new IP settings for the wireless bridge before connecting
it to your network.
Chapter 5
5-1
Advertisement
Table of Contents
