SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 100

System Configuration
CLI Commands for RADIUS MAC Authentication – Use the
mac-authentication server command from the global
configuration mode to enable remote MAC authentication. Set the
timeout value for re-authentication using the mac-authentication
session-timeout command. Be sure to also configure
connection settings for the RADIUS server (not shown in the
following example). To display the current settings, use the show
authentication command from the Exec mode.
AP(config)#mac-authentication server remote
AP(config)#mac-authentication session-timeout 300
AP(config)#exit
AP#show authentication
Authentication Information
=========================================================
MAC Authentication Server
MAC Auth Session Timeout Value : 300 secs
802.1X
Broadcast Key Refresh Rate
Session Key Refresh Rate
802.1X Session Timeout Value
Address Filtering
System Default : DENY addresses not found in filter table.
Filter Table
MAC Address
-----------------
00-70-50-cc-99-1a
00-70-50-cc-99-1b
=========================================================
AP#
6-24
: REMOTE
: DISABLED
: 5 min
: 5 min
: 300 secs
: DENIED
Status
----------
DENIED
ALLOWED
7-59
7-60
7-60