Command Mode
Global Configuration
Command Usage
• You can only configure one MAC address per wireless port
ID.
• The Ethernet MAC address for each bridge unit is printed on
the label on the back of the unit.
• When trying to connect to other bridges, please input the
Ethernet MAC address
Example
AP(config)#wds mac-address 1 00-12-34-56-78-9a
AP(config)#
wds enable
This command enables WDS forwarding for a wireless port ID.
Use the no form to disable WDS forwarding for a wireless port ID.
Syntax
[no] wds enable <port-id>
• port-id - The wireless port number for the link. (1 for Slave
units; 1-16 for Master units)
Default
WDS forwarding disabled on all ports
Command Mode
Global Configuration
Example
AP(config)#wds enable 1
AP(config)#
WDS Commands
7-63