SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 134

System Configuration
mode.
SSID Broadcast – When enabled, the access point radio does not
include its SSID in beacon messages. Nor does it respond to
probe requests from clients that do not include a fixed SSID.
(Default: Disable)
Turbo Mode – The normal 802.11a wireless operation mode
provides connections up to 54 Mbps. Turbo Mode is an enhanced
mode (not regulated in IEEE 802.11a) that provides a higher data
rate of up to 108 Mbps. Enabling Turbo Mode allows the wireless
bridge to provide connections up to 108 Mbps. (Default: Disabled)
Note: In normal mode, the wireless bridge provides a channel
bandwidth of 20 MHz, and supports the maximum number of
channels permitted by local regulations (e.g., 11 channels for the
United States). In Turbo Mode, the channel bandwidth is
increased to 40 MHz to support the increased data rate. However,
this reduces the number of channels supported (e.g., 5 channels
for the United States).
Radio Channel – The radio channel that the
wireless bridge uses to communicate with
wireless clients. When multiple wireless
bridges are deployed in the same area, set the
channel on neighboring wireless bridges at
least four channels apart to avoid interference
with each other. For example, in the United
States you can deploy up to four wireless
bridges in the same area (e.g., channels 36,
56, 149, 165). Also note that the channel for
wireless clients is automatically set to the same
as that used by the wireless bridge to which it
is linked. (Default: Channel 60 for normal
mode, and channel 42 for Turbo mode)
6-58
Normal Mode
Turbo Mode