Radius - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

System Configuration
AP(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
AP(if-ethernet)#no ip dhcp
AP(if-ethernet)#ip address 192.168.1.2
255.255.255.0 192.168.1.253
AP(if-ethernet)#dns primary-server 192.168.1.55
AP(if-ethernet)#dns secondary-server 10.1.0.55
AP(config)#end
AP#show interface ethernet
Ethernet Interface Information
========================================
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Admin status
Operational status
========================================
AP#

Radius

Remote Authentication Dial-in User Service (RADIUS) is an
authentication protocol that uses software running on a central
server to control access to RADIUS-aware devices on the
network. An authentication server contains a database of user
credentials for each user that requires access to the network.
A primary RADIUS server must be specified for the access point
to implement IEEE 802.1X network access control and Wi-Fi
Protected Access (WPA) wireless security. A secondary RADIUS
server may also be specified as a backup should the primary
server fail or become inaccessible.
Note: This guide assumes that you have already configured RADIUS
server(s) to support the access point. Configuration of RADIUS
server software is beyond the scope of this guide, refer to the
documentation provided with the RADIUS server software.
6-10
: 192.168.1.2
: 255.255.255.0
: 192.168.1.253
: 192.168.1.55
: 10.1.0.55
: Up
: Up
7-91
7-94
7-93
7-92
7-92
7-11
7-96