Vlan - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Command Line Interface
Note: Before enabling VLANs on the
the connected LAN switch port to accept tagged VLAN packets
with the
to the
feature.
The VLAN commands supported by the wireless bridge are listed
below.
Command

vlan

native-vlanid
vlan
This command enables VLANs for all traffic. Use the no form to
disable VLANs.
Syntax
vlan enable
no vlan
Default
Disabled
Command Mode
Global Configuration
Command Description
• Changing the VLAN status of the wireless bridge forces a
system reboot.
• When VLANs are enabled, the wireless bridge tags frames
received from wireless interface with the configured native
VLAN ID.
• Traffic entering the Ethernet port must be tagged with a
VLAN ID that matches the wireless bridge's native VLAN ID.
7-124
wireless bridge
will be lost when you enable the VLAN
wireless bridge
Function
Enables a single VLAN for all traffic
Configures the native VLAN for the
access point
wireless bridge
's native VLAN ID. Otherwise, connectivity
, you must configure
Mode Page
GC 7-124
GC 7-125