Ip Pppoe - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Command
pppoe lcp
echo-failure
pppoe local ip
pppoe remote ip
pppoe username
pppoe password
pppoe
service-name
pppoe restart
show pppoe

ip pppoe

This command enables Point-to-Point Protocol over Ethernet
(PPPoE) on the Ethernet interface. Use the no form to disable
PPPoE on the Ethernet interface.
Syntax
ip pppoe
no ip pppoe
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Function
Sets LCP echo timeout for the
PPPoE tunnel
Sets local IP address for the PPPoE
tunnel
Sets remote IP address for the
PPPoE tunnel
Sets the user name for the PPPoE
tunnel
Sets the password for the PPPoE
tunnel
Sets the service name for the
PPPoE tunnel
Restarts the PPPoE connection with
updated parameters
Shows information about the
PPPoE configuration
PPPoE Commands
Mode Page
IC-E
IC-E
IC-E
IC-E
IC-E
IC-E
IC-E
PE
7-85
7-86
7-86
7-87
7-88
7-89
7-89
7-90
7-81