Table of Contents
Advertisement
Command Line Interface
Command Usage
This command sets the maximum time (in seconds) a device
can wait without receiving a configuration message before
attempting to reconfigure. All device ports (except for
designated ports) should receive configuration messages at
regular intervals. Any port that ages out STP information
(provided in the last configuration message) becomes the
designated port for the attached LAN. If it is a root port, a new
root port is selected from among the device ports attached to
the network.
Example
AP(config)#bridge stp-bridge max-age 40
AP(config)#
bridge stp-bridge priority
Use this command to configure the spanning tree priority globally
for the wireless bridge. Use the no form to restore the default.
Syntax
bridge stp-bridge priority priority
no bridge stp-bridge priority
priority - Priority of the bridge. (Range: 0 - 65535)
Default Setting
32768
Command Mode
Global Configuration
7-70
Advertisement
Table of Contents
