Table of Contents
Advertisement
Initial Configuration
After configuring the wireless bridge's IP parameters, you can
access the management interface from anywhere within the
attached network. The command line interface can also be
accessed using Telnet from any computer attached to the
network.
Using the Web-based Management
Setup Wizard
There are only a few basic steps you need to complete to set up
the wireless bridge for your network. The Setup Wizard takes you
through configuration procedures for the radio channel selection,
IP configuration, and basic WEP encryption for wireless security.
The wireless bridge can be managed by any computer using a
web browser (Internet Explorer 5.0 or above, or Netscape
Navigator 6.2 or above). Enter the IP configured for the unit or the
default IP address: http://192.168.2.2
Logging In – Enter the default username "admin" and password
"smcadmin" click LOGIN. For information on configuring a user
name and password, refer to page 6-33.
5-4
Advertisement
Table of Contents
