SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 147

CLI Commands for AES Security – From the 802.11a interface
configuration mode, use the encryption command to enable AES
encryption. To enter AES keys, use the key command. To view
the current security settings, use the show interface wireless a
command.
AP(config)#interface wireless a
Enter Wireless configuration commands, one per line.
AP(if-wireless a)#encryption wdsaes alphanumeric
AP(if-wireless a)#key wdsaes 1 agoodsecretkey
AP(if-wireless a)#exit
AP#show interface wireless a
Wireless Interface Information
===========================================================
----------------Identification-----------------------------
Description
Bridge/AP
Service Type
SSID
Turbo Mode
Channel
Status
----------------802.11 Parameters--------------------------
Transmit Power
Max Station Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
DTIM Interval
Maximum Association
----------------Security-----------------------------------
Encryption
AES Key type
===========================================================
AP#
Note: The key type value entered using the key command must be the
same as the type specified in the encryption command.
: Enterprise 802.11a Wireless Outdoor
: WDS Bridge
: DualBandOutdoor
: OFF
: 36
: Disable
: FULL (15 dBm)
: 54Mbps
: 2346 bytes
: 2347 bytes
: 100 TUs
: 2 beacons
: 64 stations
: 128-BIT AES ENCRYPTION
: Alphanumeric
Radio Interface
7-110
7-112
7-120
6-71
7-99