Configuring Sntp - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

System Configuration
CLI Commands for System Logging – To enable logging on the
wireless bridge, use the logging on command from the global
configuration mode. The logging level command sets the
minimum level of message to log. Use the logging console
command to enable logging to the console. Use the logging host
command to specify up to four Syslog servers. The CLI also
allows the logging facility-type command to set the facility-type
number to use on the Syslog server. To view the current logging
settings, use the show logging command.
AP(config)#logging on
AP(config)#logging level alert
AP(config)#logging console
AP(config)#logging host 1 10.1.0.3 514
AP(config)#logging facility-type 19
AP(config)#exit
AP#show logging
Logging Information
============================================
Syslog State
Logging Host State
Logging Console State
Server Domain name/IP
Logging Level
Logging Facility Type
=============================================
AP#

Configuring SNTP

Simple Network Time Protocol (SNTP) allows the wireless bridge
to set its internal clock based on periodic updates from a time
server (SNTP or NTP). Maintaining an accurate time on the
wireless bridge enables the system log to record meaningful
dates and times for event entries. If the clock is not set, the
wireless bridge will only record the time from the factory default
set at the last bootup.
6-40
: Enabled
: Enabled
: Enabled
: 1 10.1.0.3
: Error
: 16
7-24
7-25
7-25
7-24
7-26
7-27