Bridge Commands
The commands described in this section are used to set the MAC
address table aging time and spanning tree parameters for both
the Ethernet and wireless interfaces.
Command
bridge timeout
bridge stp-bridge
spanning-tree
bridge stp-bridge
forward-time
bridge stp-bridge
hello-time
bridge stp-bridge
max-age
bridge stp-bridge
priority
bridge stp-port
path-cost
bridge stp-port
priority
bridge stp-port
portfast
bridge stp-port
spanning-disabled
show bridge
Function
Sets the aging time for the address
table
Enables the spanning tree protocol
for the bridge
Configures the spanning tree
bridge forward time
Configures the spanning tree
bridge hello time
Configures the spanning tree
bridge maximum age
Configures the spanning tree
bridge priority
Configures the spanning tree path
cost of a port
Configures the spanning tree
priority of a port
Sets a port to fast forwarding
Disables the spanning tree protocol
on a port
Displays the current aging time
settings
Bridge Commands
Mode Page
GC
GC
GC
GC
GC
GC
GC
GC
GC
GC
Exec
7-66
7-66
7-67
7-68
7-69
7-70
7-71
7-72
7-73
7-74
7-75
7-65