Initial Setup Through The Cli; Initial Configuration Steps - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Initial Configuration

Initial Setup through the CLI

The wireless bridge provides access to the CLI through a Telnet
connection. You can open a Telnet session by performing these
steps:
1. From the host computer, enter the Telnet command and the IP
address of the wireless bridge unit (default 192.168.2.2 if not
set via DHCP).
2. At the prompt, enter "admin" for the user name.
3. The default password is "smcadmin".
The CLI will display the "Dual Outdoor#" prompt to show that you
are using executive access mode (i.e., Exec).
Username: admin
Password:
Dual Outdoor#
For a full description of how to use the CLI, see "Using the
Command Line Interface" on page 7-1. For a list of all the CLI
commands and detailed information on using the CLI, refer to
"Command Groups" on page 7-9.

Initial Configuration Steps

Setting the Country Code – Regulations for wireless products
differ from country to country. Setting the country code restricts
the wireless bridge to use only the radio channels and power
settings permitted in the specified country of operation. If the
wireless bridge unit is shipped with a preset country code, you
are not permitted to change it, as required by country regulations.
If the unit is set to the default "99," you must set the country code
to the country of operation.
5-2