SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 108

System Configuration
Trap Destination Community Name – The community string sent
with the notification operation. (Maximum length: 23 characters;
Default: public)
CLI Commands for SNMP – Use the snmp-server enable
server command from the global configuration mode to enable
SNMP. To set read/write and read-only community names, use
the snmp-server community command. The snmp-server host
command defines a trap receiver host. To view the current SNMP
settings, use the show snmp command.
AP(config)#snmp-server enable server
AP(config)#snmp-server community alpha rw
AP(config)#snmp-server community beta ro
AP(config)#snmp-server host 10.1.19.23 alpha
AP(config)#exit
AP#show snmp
SNMP Information
============================================
Service State
Community (ro) : ****
Community (rw) : *****
Location
Contact
Traps
Host Name/IP
Trap Community : *****
=============================================
AP#
6-32
: Enable
: building-1
: Paul
: Enabled
: 10.1.19.23
7-36
7-34
7-37
7-39