Table of Contents
Advertisement
• Where more than one port is assigned the highest priority,
the port with lowest numeric identifier will be enabled.
Example
AP(config)#bridge stp-port priority 1 64
AP(config)#
Related Commands
bridge stp-port path-cost (page 7-71)
bridge stp-port portfast
Use this command to set an interface to fast forwarding. Use the
no form to disable fast forwarding.
Syntax
bridge stp-port portfast <port>
no bridge stp-port portfast <port>
port - Specifies the port number on the wireless bridge.
(Range: 0, Ethernet interface; 1-16 wireless interface)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• This command is used to enable/disable the fast
spanning-tree mode for the selected port. In this mode,
ports skip the Discarding and Learning states, and proceed
straight to Forwarding.
Bridge Commands
7-73
Advertisement
Table of Contents
