Show Filters; Pppoe Commands - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Command Line Interface

show filters

This command shows the filter options and protocol entries in the
filter table.
Command Mode
Exec
Example
AP#show filters
Protocol Filter Information
=========================================================
AP Management
Ethernet Type Filter :ENABLED
Enabled Protocol Filters
---------------------------------------------------------
Protocol: ARP
=========================================================
AP#

PPPoE Commands

The commands described in this section configure PPPoE
management tunnel connection parameters for the Ethernet port.
Command
ip pppoe
pppoe ip allocation
mode
pppoe ipcp dns
pppoe lcp
echo-interval
7-80
:ENABLED
Function
Enables PPPoE on the Ethernet
interface
Specifies how IP addresses for the
PPPoE tunnel are configured on the
interface
Negotiates DNS for the PPPoE
tunnel
Sets LCP echo interval for the
PPPoE tunnel
ISO: 0x0806
Mode Page
IC-E 7-81
IC-E 7-82
IC-E 7-83
IC-E 7-84