SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 131

RSSI – The RSSI value for a selected port can be displayed and
a representative voltage output can be enabled.
•
Output Activate: Enables or disables the RSSI voltage output
on the external RSSI connector. (Default: Enabled)
•
Port Number: Selects a specific WDS port for which to set the
maximum RSSI output voltage level. Ports 1-16 are available
for a Master unit, only port 1 for a Slave unit. (Default: 1)
•
Output Value: The maximum RSSI voltage level for the current
selected WDS port. A value of zero indicates that there is no
received signal or that the WDS port is disabled.
Distance – This value is used to adjust timeout values to take into
account transmit delays due to link distances in the wireless
bridge network. For a point-to-point link, specify the approximate
distance between the two bridges. For a point-to-multipoint
network, specify the distance of the Slave bridge farthest from the
Master bridge
•
Mode: Indicates if the 802.11a radio is operating in normal or
Turbo mode. (See "Radio Settings A" on page 6-57.)
•
Distance: The approximate distance between antennas in a
bridge link.
Note: There are currently no equivalent CLI commands for the RSSI
controls.
Advanced Configuration
6-55