Snmp Commands; Snmp-Server Community - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Command Line Interface

SNMP Commands

Controls access to this wireless bridge from management
stations using the Simple Network Management Protocol
(SNMP), as well as the hosts that will receive trap messages.
Command
snmp-server
community
snmp-server
contact
snmp-server
enable server
snmp-server host Specifies the recipient of an SNMP
snmp-server
location
show snmp

snmp-server community

This command defines the community access string for the
Simple Network Management Protocol. Use the no form to
remove the specified community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
• string - Community string that acts like a password and
permits access to the SNMP protocol. (Maximum length: 23
characters, case sensitive)
• ro - Specifies read-only access. Authorized management
stations are only able to retrieve MIB objects.
• rw - Specifies read/write access. Authorized management
stations are able to both retrieve and modify MIB objects.
7-34
Function
Sets up the community access string
to permit access to SNMP commands
Sets the system contact string
Enables SNMP service and traps
notification operation
Sets the system location string
Displays the status of SNMP
communications
Mode Page
GC 7-34
GC 7-35
GC 7-36
GC 7-37
GC 7-38
Exec 7-39