Table of Contents
Advertisement
Command Line Interface
Example
AP(config)#snmp-server contact Paul
AP(config)#
Related Commands
snmp-server location (page 7-38)
snmp-server enable server
This command enables SNMP management access and also
enables this device to send SNMP traps (i.e., notifications). Use
the no form to disable SNMP service and trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• This command enables both authentication failure
notifications and link-up-down notifications.
• The snmp-server host command specifies the host device
that will receive SNMP notifications.
Example
AP(config)#snmp-server enable server
AP(config)#
Related Commands
snmp-server host (page 7-37)
7-36
Advertisement
Table of Contents
