SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual page 105

•
Enable: Wireless bridge filters Ethernet protocol types based
on the configuration of protocol types in the filter table. If a
protocol has its status set to "ON," the protocol is filtered from
the wireless bridge.
CLI Commands for VLAN Support – From the global
configuration mode use the native-vlanid command to set the
default VLAN ID for the Ethernet interface, then enable VLANs
using the vlan enable command. When you change the access
point's VLAN support setting, you must reboot the access point to
implement the change. To view the current VLAN settings, use
the show system command.
AP(config)#native-vlanid 3
7-125
AP(config)#vlan enable
7-124
Reboot system now? <y/n>: y
CLI Commands for Bridge Filtering – Use the filter ap-manage
command to restrict management access from wireless clients.
To configure Ethernet protocol filtering, use the filter
ethernet-type enable command to enable filtering and the filter
ethernet-type protocol command to define the protocols that
Advanced Configuration
6-29