Wds Channel; Wds Mac-Address - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

Command Line Interface

wds channel

This command selects the radio band to be used for WDS
forwarding (bridging).
Syntax
wds channel <a | g | none>
• a - Bridging is supported on the 802.11a 5 GHz band.
• g - Bridging is supported on the 802.11b/g 2.4 GHz band.
• none - Bridging is not supported for either band.
Default
802.11a
Command Mode
Global Configuration
Example
AP(config)#wds channel a
AP(config)#

wds mac-address

This command enters Ethernet MAC Addresses in the WDS
forwarding table for each node in the wireless bridge network.
Syntax
wds mac-address <port-id> <mac-address>
• port-id - The wireless port number for the bridge link. (1 for
Slave units; 1-16 for Master units)
• mac-address - The Ethernet MAC Address of the remote
bridge unit for this link. (12 hexadecimal digits in the form
"xx-xx-xx-xx-xx-xx")
Default
none
7-62