Authentication - SMC Networks ElliteConnect 2.4GHz/5GHz Owner's Manual

System Configuration
AP(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
AP(if-ethernet)#ip pppoe
AP(if-ethernet)#pppoe username mike
AP(if-ethernet)#pppoe password 12345
AP(if-ethernet)#pppoe service-name classA
AP(if-ethernet)#pppoe ip allocation mode static
AP(if-ethernet)#pppoe local ip 10.7.1.200
AP(if-ethernet)#pppoe remote ip 192.168.1.20
AP(if-ethernet)#pppoe ipcp dns
AP(if-ethernet)#pppoe lcp echo-interval 30
AP(if-ethernet)#pppoe lcp echo-failure 5
AP(if-ethernet)#pppoe restart
AP(if-ethernet)#end
AP#show pppoe
PPPoE Information
======================================================
State
Username
Service Name
IP Allocation Mode
DNS Negotiation
Local IP
Echo Interval
Echo Failure
======================================================
AP#

Authentication

Wireless clients can be authenticated for network access by
checking their MAC address against the local database
configured on the access point, or by using a database
configured on a central RADIUS server. Alternatively,
authentication can be implemented using the IEEE 802.1X
network access control protocol.
The access point can also operate in a 802.1X supplicant mode.
This enables the access point itself and any bridge-connected
units to be authenticated with a RADIUS server using a
configured MD5 user name and password. This mechanism can
prevent rogue access points from gaining access to the network.
6-16
: Link up
: mike
: classA
: Static
: Enabled
: 10.7.1.200
: 30
: 5
7-91
7-81
7-87
7-88
7-89
7-82
7-86
7-86
7-83
7-84
7-85
7-89
7-90