Table of Contents
Advertisement
Turning on the platform and setting up the VWorks software
Before you start
Turning on the AssayMAP Bravo Platform
AssayMAP Bravo Platform Installation Guide
You must set up the AssayMAP Bravo Platform in the VWorks software before
you can safely run the protocols in the Protein Sample Prep Workbench. Make
sure that you perform the following steps in the order given to set up the
AssayMAP Bravo Platform.
WARNING
To avoid potential injury and damage to the device, only personnel trained in
how to teach the AssayMAP Bravo Platform should perform the setup procedures.
Workflow
Step
For this task...
1
If you have not already done
so, turn on the AssayMAP
Bravo Platform.
2
Understand the device profile
requirements
3
Start the VWorks software,
establish communication with
the device, and then verify the
device profile settings for this
installation.
To turn on the platform:
1
If you have not already done so, turn on any accessories, such as the Pump
Module. If applicable, ensure that the Inheco STC Controller and the
control module for the Orbital Shaking Station are turned on.
2
Turn on the computer, and start the Microsoft Windows operating system.
3
On the side of the AssayMAP Bravo Platform, press the power switch to
the on (|) position.
Setting up the computer and software
Turning on the platform and setting up the VWorks software
See...
"Turning on the AssayMAP Bravo
Platform" on page 37
"Device profile requirements" on
page 38
"Verifying the profile settings and
configuration" on page 39
37
Advertisement
Table of Contents
