Agilent Technologies AssayMAP Bravo Installation Manual page 96

Verifying the installation and setup
Washing the syringes to prepare for first time use
88
4
In the Labware Table area, select the labware for Deck Location 4 that matches
the filled labware from step 1.
Note: Deck locations 3 and 5–9 will not be used in this configuration.
Leave the labware selections at the default setting for these locations.
Do not place labware on the deck at these locations.
5
Under Wash Settings, set the following:
Setting
Initial Syringe Rinses
Final Syringe Rinses
6
For Wash 1, set the following:
Setting
Buffer
Wash Type
Wash Volume (µL)
Wash Cycles
Rinse after Each Wash Cycle
Wash Rate (µL/sec)
Rinse Cycles
7
For Wash 2–Wash 6, set Wash Cycles to 0.
Value
0
0
Value
1
Cycle in Reservoir
250
20
Clear the check box
200
0
AssayMAP Bravo Platform Installation Guide