Agilent Technologies AssayMAP Bravo Installation Manual page 14

Installing the platform
Installing the Bravo risers
6
2
Ensure that the head mount is resting against the Bravo back plate. With a
person positioned on each side of the Bravo Platform, slowly tilt the device
backwards until the back plate rests on the foam.
3
Remove the four rubber feet from the base of the Bravo deck.
Figure Bottom view of Bravo deck
4
On the bottom of the Bravo deck, install the two risers, one on each side.
Use the four screws and washers provided to install each riser. Tighten the
screws as follows:
a
Tighten the screws at the top first, and then tighten the screws at the
bottom, as the following figures show.
b
Tighten the screws until snug, and ensure that the risers are flush to
the base of the Bravo deck.
Figure Top screw located at inner hole
AssayMAP Bravo Platform Installation Guide