Agilent Technologies AssayMAP Bravo Installation Manual page 58

Setting up the computer and software
Verifying the Orbital Shaking Station configuration
50
If the accessory is not yet configured at this location, in the Choose
Accessory page, choose the Orbital Shaking Station.
6
In the Properties table, verify the Serial Port number and Module Number,
and then click Next.
Property
Serial Port
Module Number
*The Serial Port parameter will be automatically defined when a USB- to-
serial adapter is connected to the computer. You might need to lookup the
port assigned to this device in the Windows Device Manager.
Note: Occasionally, a port number is reassigned for a USB- to- serial
connection if you disconnect and reconnect the accessory. If this
happens, you must verify that the correct Serial Port is set in each
profile.
7
Click Finish. The Bravo Accessories Wizard closes.
8
If the accessory configuration message appears, click Yes to move the
teachpoint to a safe height.
9
If you made any changes to the configuration settings, click the Profiles tab,
and then click Update this profile to save the changes.
Setting
1*
1
AssayMAP Bravo Platform Installation Guide