Omron R88M-K Series User Manual page 534

9-4 Setting the Mode
operation
7. Returning to Parameter Write Mode
operation
8. Restart the power supply to the drive
9
 The items that are limited depend on the mode.
 If the Front Panel Parameter Write Selection (Pn617) is set to 1, the parameter set value is
automatically written to EEPROM when changed.
 Refer to the Front Key Protection Setting (Pn535) in "8-6 Extended Parameters" (P.8-47) for
details on the front panel lock function.
9-31
Key
Display example
Key
Display example
Precautions for Correct Use
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Explanation
Press and hold the key for 5 seconds or longer until
is displayed.
The bar indicator will increase.
Writing will start. (This display will appear only momentarily.)
This indicates a normal completion. In addition to this display,
either or
If is displayed, writing has been completed normally,
but some of the changed parameters will be valid only after the
power supply has been turned OFF and ON again. Turn OFF the
drive power supply and then turn it ON again.
will be displayed if there is a write alarm. Write the
data again.
Explanation
Press the key to return to Parameter Write Mode.
may be displayed.