Omron R88M-K Series User Manual page 519

Number Item
Other reasons
14
Note.The motor may rotate even if a reason number other than 0 is displayed.
Display of the Number of I/O Signal Changes
I/O signal change count
Pin number
...Input signal
...Output signal
 Display the number of transitions in one input since last power-on.
Absolute Encoder Data
Encoder data
...1-rotation data, lower (L)
...1-rotation data, higher (H)
...Multi-rotation data
Press
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Relevant
control
mode
Reasons 1 to 13 do not apply, but the motor is rotating at 20 r/min or
All lower. (Low command, heavy, locked, or crashed load, faulty drive
or motor, etc.)
If the decimal point is on the right side of the pin number,
the pin number can be changed.
Use to move the flashing decimal point.
If the decimal point is between the pin numbers,
you can switch between input and output.
Press to switch between input and output.
to select the data you want to display.
9-4 Setting the Mode
Description
9
9-16