Omron R88M-K Series User Manual page 497

Pn615
Overspeed Detection Level Setting at Immediate Stop
Setting
0 to 20,000
range
 Set overspeed detection level upon generation of immediate stop alarm.
The overspeed detection level setting will be 1.2 times the maximum motor rotation speed if this
parameter is set to 0.
This parameter should normally be set to 0. The setting should be changed only when it is
necessary to lower the overspeed detection level.
The set value of this parameter is limited to 1.2 times the maximum motor rotation speed.
Pn616
Absolute Interface Function Selection
Setting
0 or 1
range
Explanation of Set Values
Set value
0 Disabled
1 Enabled
 Set this parameter to 1.
Pn617
Front Panel Parameter Write Selection
Setting
0 or 1
range
Explanation of Set Values
Set value
0 EEPROM write not performed when a parameter is changed from the front panel
1 EEPROM write performed at the same time
 Set the EEPROM write conditions when the front panel parameter is changed.
Pn618
Power Supply ON Initialization Time
Setting
0 to 100
range
 Set initialization time after power supply ON to the standard 1.5 seconds plus some.
Pn619
Encoder Phase-Z Setting
Setting
0 to 32,767
range
 Finely adjust the ON width of encoder phase-Z signal output.
 This is enabled when the phase-Z output and phase-A output are not synchronized (Pn011/Pn503
× Encoder resolution is not a multiple of 4) due to the encoder dividing ratio setting.
The set value of Pn619 and the ON width of phase-Z output are related as follows:
Phase-Z output width [s] = 30/(Pn619 × Motor speed [r/min])
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Unit r/min
−
Unit
Explanation
−
Unit
Explanation
Unit 0.1 s
Unit Pulse
8-7 Special Parameters
Default Power OFF
0
setting and ON
Default Power OFF
1
setting and ON
Default Power OFF
0
setting and ON
Default Power OFF
0
setting and ON
Default
Power OFF
0
setting and ON
All
−
All
Yes
All
Yes
8
All
Yes
All
Yes
8-62