Omron R88M-K Series User Manual page 494

8-6 Extended Parameters
Pn532
Command Pulse Input Maximum Setting
Setting
250 to 4,000
range
 Set the maximum number of pulses for a command pulse input. If the command pulse input
frequency exceeds 1.2 multiplied by this set value, alarm 27.0 (command pulse frequency error)
will occur.
Command pulse input frequency errors are detected for the number of pulses that are received by
the Servo Drive. If the number of pulses that is input greatly exceeds this set value, normal
detection of the error may not be possible. Also, if the set value is less than 1,000, one of the
following digital filters is applied to the command pulse input.
250 to 499
500 to 999
1,000 to 4,000
Pn533
Pulse Regeneration Output Limit Setting
Setting
0 or 1
range
Explanation of Set Values
value
8
0
1
Set the detection of Alarm 28.0 "pulse regeneration error".
Pn535
Front Key Protection Setting
Setting
0 or 1
range
Explanation of Set Values
value
0
1
 Set the operation limitation from the front panel.
 The operation limits depend on the mode. The operation limits are as follows.
Monitor Mode
Parameter Setting Mode
EEPROM Write Mode
Auxiliary Function Mode
8-59
Unit
Pn532 set value
Unit
Set
Error detection disabled
Error detection enabled
Unit
Set
Front panel operation not blocked
Front panel operation blocked
Mode
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Default
kpps
setting
200 ns × 2 readings
100 ns × 2 readings
None (through)
Default
−
setting
Description
Default
−
setting
Description
Operation limits
All monitor data can be checked.
Parameters cannot be changed. However, parameter set values can
be checked.
Cannot be executed. (Will not be displayed)
Operations other than the release of the front key protection setting
cannot be executed. (Will not be displayed)
Position Fully-closed
Power OFF
4000
and ON
Digital filter
Power OFF
0
and ON
Power OFF
0
and ON
Yes
All
Yes
All
Yes