3-4 Cable and Connector Specifications
Connector-Terminal Block Conversion Unit
The Connector-Terminal Block Conversion Unit connects the servo drive I/O signals (CN1
connector) for general purpose. Use the cable (XW2Z-@J-B24) to connect the Connector-
Terminal Block Conversion Unit to the CN1 connector.
XW2B-50G4 (M3 Screw Terminal Block)
3
Dimensions
Flat cable connector (MIL type plug)
3.5
157.5
3.5
15.5
29.5
45
2-φ3.5
5.08
Terminal block
(45.3)
38.1
20.5
2
Use 0.3 to 1.25 mm
wire (AWG22 to 16).
The wire inlet is 1.8 mm (height) × 2.5 mm (width).
Strip the insulation from the end of the wire for 6 mm as shown below.
6 mm
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
3-124