Upgrading The Optical Inline Amplifier From The Junos Os Cli - Juniper PTX3000 IPLC Features Manual

Chapter 6: Configuring the Optical Supervisory Channel in the Amplifier Chain When Using the Optical Inline Amplifier
Related
Documentation

Upgrading the Optical Inline Amplifier from the Junos OS CLI

Copyright © 2018, Juniper Networks, Inc.
Understanding Optical Supervisory Channel Communication in the Amplifier Chain on
page 11
Configuring the Optical Supervisory Channel Across the Amplifier Chain of the PTX3000
Integrated Photonic Line System on page 33
Configuring the IP Address of an Optical Inline Amplifier on page 39
Upgrading the Optical Inline Amplifier from the Junos OS CLI on page 41
Starting with Junos OS Release 17.1R1, you can upgrade Juniper Networks optical inline
amplifiers (ILA)s using the Junos OS CLI. This topic describes how to upgrade optical
ILAs in the amplifier chain of the PTX3000 integrated photonic line system.
Before you begin:
Make sure the PTX3000 integrated photonic line system is up and operational and
passing traffic.
Make sure the optical supervisory channel is up and operational on all optical ILAs in
the amplifier chain, see
Amplifier Chain of the PTX3000 Integrated Photonic Line System" on page
Make sure a user and password is configured on each optical ILA in the amplifier chain,
see, "Configuring Optical ILA Authentication Through the Junos OS CLI" on page
NOTE: You must perform this upgrade on all optical ILAs in the amplifier
chain and all units must be running the same software release.
To upgrade the software on the optical ILA from the Junos OS CLI:
Download the correct optical ILA software package. Optical ILA software images are
1.
released separately and are not part of Junos OS releases. The optical ILA software
image filename is: IlaFirmwareBundle. Before entering CLI mode on the router, copy
the optical ILA software image to the
routing engine.
Verify that the optical ILA software image is now located in the
2.
of the PTX3000.
user@router% ls -ltr /var/tmp/IlaFirmwareBundle
-rw------- 1 field
user@router%
Enter CLI mode and from the
3.
In the following example, the IPLC module resides in FPC slot 5 and the optical ILA
being upgraded is ila-2.
"Configuring the Optical Supervisory Channel Across the
directory on the PTX3000 master
/var/tmp/
11455488 Nov 21 14:26 /var/tmp/IlaFirmwareBundle
configuration hierarchy, run the upgrade command.
[edit]
33.
40.
directory
/var/tmp/
41