YASKAWA Z1000 User Manual page 135

n L6-03: Torque Detection Time 1
Determines the time required to trigger an alarm or fault after exceeding the level in L6-02.
No.
L6-03
n o2-03: User Parameter Default Value
After completely setting up drive parameters, save the values as user-set defaults with parameter o2-03. After saving the values,
parameter A1-03 (Initialize Parameters) will offer the choice of "1110: User Initialize". Selecting 1110 resets all parameters
to the user-set default values.
No.
o2-03
Setting 0: No Change (Awaiting Command)
Setting 1: Set User Initialize Values
The current parameter settings are saved as user-set default for a later User Initialization. Setting o2-03 to 1 and pressing the
ENTER key saves the values and returns the display to 0.
Setting 2: Clear User Initialize Values
All user-set defaults for "User Initialize" are cleared. Setting o2-03 to 2 and pressing the ENTER key erases the values and
returns the display to 0.
n o2-05: Frequency Reference Setting Method Selection
Determines if the ENTER key must be pressed after changing the frequency reference using the HOA keypad while in Drive
Mode.
No.
o2-05 Frequency Reference Setting Method Selection
Setting 0: ENTER Key Required
The ENTER key must be pressed every time the frequency reference is changed using the HOA keypad for the drive to accept
the change.
Setting 1: ENTER Key not Required
The output frequency changes immediately when the reference is changed by the up or down arrow keys on the HOA keypad.
The ENTER key does not need to be pressed. The frequency reference (Fref) is saved to memory after remaining unchanged
for 5 seconds.
YASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual
Name
Torque Detection Time 1
Refer to A1-03: Initialize Parameters on page 151
Name
User Parameter Default Value
Name
4.7 Basic Drive Setup Adjustments
Setting Range
0.0 to 10.0 s
for details on drive initialization.
Setting Range
0 to 2
Setting Range
0, 1
Default
10.0 s
Default
0
Default
0
4
135