Copy Function Related Displays; Copy Function Related Displays; Tasks, Errors, And Troubleshooting - YASKAWA Z1000 User Manual

5.8

Copy Function Related Displays

u

Tasks, Errors, and Troubleshooting

The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the HOA keypad will indicate the task being performed. When an
error occurs, a code appears on the HOA keypad to indicate the error. Note that errors related to the Copy function do not
trigger a multi-function output terminal that has been set up to close when a fault or alarm occurs. Press any key on the HOA
keypad to clear an error; the error display will disappear.
Table 5.14 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a drive when the voltage class, capacity, control mode, and software version match.
HOA Keypad Display
CoPy
Cause
Parameters are being written to the drive.
HOA Keypad Display
CPEr
Cause
Control mode of the parameters to be loaded onto the
drive and the control mode set to the drive do not
match.
HOA Keypad Display
CPyE
Cause
Failed writing parameters
HOA Keypad Display
CSEr
Cause
Hardware fault
HOA Keypad Display
dFPS
Cause
The drives used in the copy and write process are not
the same model.
• The drive from which the parameters were copied
is a different model.
• The drive to be written to is a different model.
HOA Keypad Display
End
Cause
Finished reading, writing, or verifying parameters. This is not an error.
YASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual
Table 5.14 Copy Function Task and Error Displays
Writing Parameter Settings (flashing)
This is not an error.
Control Mode Mismatch
• Verify the control mode for the parameters to be loaded onto the drive and the control mode on
drive to which those parameters will be written.
• Set the same control mode using parameter A1-02 and retry.
Error Writing Data
Attempt to write parameters again.
Copy Unit Error
Replace the operator or the USB Copy Unit.
Drive Model Mismatch
• Verify the model number of the drive from which the parameters were copied and the model of
the drive to which those parameters will be written.
• Make sure the two drives are the same model and have the same software version.
Task Complete

5.8 Copy Function Related Displays

Task
Possible Solutions
Error
Possible Solutions
Error
Possible Solutions
Error
Possible Solutions
Error
Possible Solutions
Task
Possible Solutions
5
231