Changing Parameter Settings Or Values - YASKAWA Z1000 User Manual

n Drive Mode Details
The following actions are possible in the Drive Mode:
• Run and stop the drive
• Monitor the operation status of the drive (frequency reference, output frequency, output current, output voltage, etc.)
• View information on an alarm
• View a history of alarms that have occurred
n Programming Mode Details
The following actions are possible in the Programming Mode:
• Parameter Setting Mode: Access and edit all parameter settings.
• Verify Menu: View a list of parameters that have been changed from the default values.
• Setup Group: Access a list of commonly used parameters to simplify setup
Group on page 111).
• Auto-Tuning Mode: Automatically calculate and set motor parameters to optimize drive performance.
u

Changing Parameter Settings or Values

This example explains changing C1-02 (Deceleration Time 1) from 30.0 seconds (default) to 20.0 seconds.
1. Turn on the power to the drive. The initial display appears.
2. Press
or until the Parameter Setting Mode screen appears.
3. Press
to enter the parameter menu tree.
4. Press
or to select the C parameter group.
5. Press
two times.
6. Press
or to select parameter C1-02.
7. Press
to view the current setting value (10.0 s). The leftmost digit flashes.
8. Press
F2
F1
, , or
YASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual
4.3 The Drive, Programming, and Clock Adjustment Modes
Step
until the desired number is selected. "1" flashes.
(Refer to Simplified Setup Using the Setup
Display/Result
- MODE -
Freq Ref (AI)
U1-01= 0.00Hz
U1-02= 0.00Hz
U1-03= 0.00 A
FWD
- MODE -
Programming
HELP FWD
-PRMSET-
Initialization
A1-00=
Select Language
←
FWD
-PRMSET-
Basic Setup
C1-01= 30.0 sec
Accel Time 1
← ←
FWD
-PRMSET- PRG
Accel/Decel
C1-01= 30.0 sec
Accel Time 1
← →
FWD
-PRMSET-
Decel Time 1
C1-02=
(0.0~6000.0)
"30.0 sec"
←
FWD
-PRMSET-
Decel Time 1
C1-02= 0030.0Sec
(0.0~6000.0)
"30.0 sec"
←
FWD
-PRMSET-
Decel Time 1
C1-02=0030.0Sec
(0.0~6000.0)
"30.0 sec"
←
FWD
DRV Rdy
LSEQ
LREF
PRG
DATA
PRG
0
→
PRG
→ →
-PRMSET- PRG
Accel Time 1
C1-01= 30.0Sec
(0.0~6000.0)
← "30.0 sec" →
FWD
4
PRG
30.0Sec
→
PRG
→
PRG
→
109