YASKAWA Z1000 User Manual page 164

4.13 Advanced Drive Setup Adjustments
Setting 0: "WC (Inch of Water)
Setting 1: PSI (Pounds per Square Inch)
Setting 2: GPM (Gallons per Minute)
Setting 3: F (Degrees Fahrenheit)
Setting 4: CFM (Cubic Feet per Minute)
Setting 5: CMH (Cubic Meters per Hour)
Setting 6: LPH (Liters per Hour)
Setting 7: LPS (Liters per Second)
Setting 8: Bar (Bar)
Setting 9: Pa (Pascal)
Setting 10: C (Degrees Celsius)
Setting 11: Mtr (Meters)
Setting 12: Ft (Feet)
Setting 13: LPM (Liters per Minute)
Setting 14: CMM (Cubic Meters per Minute)
n b5-47: Reverse Operation Selection 2 by PI Output
Determines whether a negative PI output reverses the direction of drive operation. When the PI function is used to trim the
frequency reference (b5-01 = 3), this parameter has no effect and the PI output will not be limited
(same as b5-11 = 1).
No.
b5-47
Setting 0: Reverse Disabled
Negative PI output will be limited to zero and the drive output will be stopped.
Setting 1: Reverse Enabled
Negative PI output will cause the drive to run in the opposite direction.
n C2-01 and C2-02: S-Curve Characteristics
C2-01 and C2-02 set separate S-curves for each section of the acceleration or deceleration.
No.
C2-01
C2-02
Figure 4.30 illustrates S-curve application.
Setting the S-curve will increase the acceleration and deceleration times.
Actual accel time = accel time setting + (C2-01 + C2-02) / 2
164
Name
Reverse Operation Selection 2 by PI Output
Parameter Name
S-Curve Characteristic at Accel Start
S-Curve Characteristic at Accel End
FWD run
REV run
C2-02
Output
frequency
C2-01
<1> S-Curve characteristic at Decel Start/End is fixed to 0.20 s.
Figure 4.30 S-Curve Timing Diagram - FWD/REV Operation
0.20 s
<1>
0.20 s
<1>
C2-01
C2-02
YASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual
Setting Range
0, 1
Setting Range
0.00 to 10.00 s
0.20 s
<1>
0.20 s
<1>
Default
1
Default
Determined by
A1-02
0.20 s