European Standards; Ce Low Voltage Directive Compliance - YASKAWA Z1000 User Manual

D.2 European Standards
D.2 European Standards
The CE mark indicates compliance with European safety and environmental regulations. It is required for engaging in business
and commerce in Europe.
European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive for electronics
manufacturers, and the EMC guidelines for controlling noise.
This drive is in conformance with the Low Voltage Directive.
• Low Voltage Directive: 2006/95/EC
Devices used in combination with this drive must also be CE certified and display the CE mark. When using drives displaying
the CE mark in combination with other devices, it is ultimately the responsibility of the user to ensure compliance with CE
standards. After setting up the device, verify that conditions meet European standards.
u

CE Low Voltage Directive Compliance

This drive has been tested according to European standard IEC/EN 61800-5-1:2007, and it fully complies with the Low Voltage
Directive.
To comply with the Low Voltage Directive, be sure to meet the following conditions when combining this drive with other
devices:
n Area of Use
Do not use drives in areas with pollution higher than degree 2 and overvoltage category 3 in accordance with IEC/EN 60664.
n Factory Recommended Branch Circuit Protection
Yaskawa recommends installing one of the following types of branch circuit protection to maintain compliance with UL508C.
Semiconductor protective type fuses are preferred. Alternate branch circuit protection devices are also listed in
NOTICE: If a fuse is blown or a Ground Fault Circuit Interrupter (GFCI) is tripped, check the wiring and the selection of peripheral devices
to identify the cause. Contact Yaskawa before restarting the drive or the peripheral devices if the cause cannot be identified.
Drive Model
5A0003
5A0004
5A0006
5A0009
5A0011
5A0017
5A0022
5A0027
5A0032
5A0041
5A0052
5A0062
5A0077
5A0099
5A0125
350
Figure D.1 CE Mark
Table D.1 Factory Recommended Drive Branch Circuit Protection
Model
Three-Phase 600 V Class
FWP-50B
FWP-50B
FWP-60B
FWP-60B
FWP-70B
FWP-100B
FWP-100B
FWP-125A
FWP-125A
FWP-175A
FWP-175A
FWP-250A
FWP-250A
FWP-250A
FWP-350A
Fuse Type
Manufacturer: Bussmann
Fuse Ampere Rating (A)
YASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual
Table D.1.
50
50
60
60
70
100
100
125
125
175
175
250
250
250
350