Table 56: Port Edit Options (continued)
Field
Function
IPv6 Address
Specifies an IPv6 address for the interface.
NOTE:
If the IPv6 Address check box is cleared, the
interface still belongs to the
Table 57: Recommended CoS Settings for Port Roles
CoS Parameter
Forwarding Classes
Schedulers
Scheduler maps
ieee-802.1 classifier
dscp classifier
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
family.
inet
Recommended Settings
There are four forwarding classes:
—Queue number is set to 7.
voice
—Queue number is set to 5.
expedited-forwarding
—Queue number is set to 1.
assured-forwarding
—Queue number is set to 0.
best-effort
The schedulers and their settings are:
Strict-priority—Transmission rate is set to 10 percent and buffer size to 5 percent.
Expedited-scheduler—Transmission rate is set to 30 percent, buffer size to 30 percent, and
priority to
.
low
Assured-scheduler—Transmission rate is set to 25 percent, buffer size to 25 percent, and
priority to
.
low
Best-effort scheduler—Transmission rate is set to 35 percent, buffer size to 40 percent, and
priority to
.
low
When a desktop and phone, routed uplink, or Layer 2 uplink role is applied on an interface, the
forwarding classes and schedulers are mapped using the scheduler map.
Imports the default
ieee-802.1
code point 101 for the
voice
Imports the default
classifier configuration and sets the loss priority to
dscp
point 101110 for the
forwarding class.
voice
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Monitoring Interface Status and Traffic on page 198
Your Action
1.
Select the
IPv6 address
IPv6 address.
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334.
3. Enter the subnet mask or address prefix.
4. Click
OK
.
NOTE:
IPv6 address is not supported on EX2200
and EX4500 switches.
classifier configuration and sets the loss priority to
forwarding class.
Chapter 9: Interfaces
check box to specify an
for the
low
for the code
low
115