Configuring Redundant Trunk Groups (J-Web Procedure) - Juniper EX Series User Manual

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
Table 54: IGMP Snooping Configuration Fields (continued)
Field
Interfaces List
Related
Documentation

Configuring Redundant Trunk Groups (J-Web Procedure)

106
Function
Statically configures an interface as a
switching interface toward a multicast
router or as a member of a multicast
group.
Example: Configuring IGMP Snooping on EX Series Switches
Configuring IGMP Snooping (CLI Procedure)
IGMP Snooping on EX Series Switches Overview
NOTE: This topic applies only to the J-Web Application package.
A redundant trunk link provides a simple solution for network recovery when a trunk
interface goes down. Traffic is routed to another trunk interface, keeping network
convergence time to a minimum. You can configure redundant trunk groups (RTGs) with
a primary link and a secondary link on trunk interfaces, or configure dynamic selection of
the active interface. If the primary link fails, the secondary link automatically takes over
without waiting for normal Spanning Tree Protocol (STP) convergence. An RTG can be
created only if the following conditions are satisfied:
A minimum of two trunk interfaces that are not part of any RTG are available.
Your Action
Click one of the following options:
Add—Adds an interface to the IGMP
snooping configuration.
1. Select an interface from the list.
For an EX8200 Virtual Chassis
configuration, select the member,
FPC, and the interface from the
list.
2. Select
Multicast Router Interface
3. Type the maximum number of
groups an interface can join.
4. In , choose one:
Static
Click , type a group IP
Add
address, and click OK
Select a group and click
to remove the group
membership.
Edit—Edits the interface settings for
the IGMP snooping configuration.
Remove—Deletes an interface
configured for IGMP snooping.
Copyright © 2017, Juniper Networks, Inc.
.
.
Remove